YOWU SELKIRK-4 Cat Ear Headphone

INSTRUCTIONS

1. Press and hold Power Button for 2 seconds to turn the headphone on, press and hold the Power Button for 3 seconds to turn the headphone off. To connect a new device, press and hold the Power Button for 5 seconds until the indicator light flash between red and blue. With the vibration the headphone will be searching new device. Then turn on your device’s Blue- tooth and connect YOWU-SELKIRK-4.
2. Use Light Button to change the RGB light. Press once to change the color of the light, press twice to change the mode of the light, hold the button to turn on/off the light.
3. TYPE-C
4. Press Vol- and Volt+ Button to adjust the headphone’s volume.

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These Imits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not instaled and used in accordance with the instructions, may cause harmtul interference to radio communications. However, there is no guarantee that interference will not occur in a particular instalation. If this equipment does cause harmful interference to radio or television reception, which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna,
• Increase the separation between the equipment and receiver,
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules, Operation is subject to the following two conditions:

1.  This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation,
   Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment,

Smart phone control is available now, scan the QR Code or search and download YOWU in app store to use.

Bluetooth pairing will start automatically after the earphones are taken out of the charging case. At this time, the headset light is in a breathing state.
Open the Bluetooth setting on your mobile phone and find ‘YOWU-SPHYNX’ to connect. When the connection is successful, the headset light is permanently on.

Answer I Hang up When wearing both earphones, double-click any headset to answer the call or end the current call.
When wearing one earphone, double-click the headset you are wearing to answer the call or hang up the current call.

Reset Bluetooth If you need to connect the headset to another mobile phone, place the headset back into the charging compartment, close the charging box press and hold the function button of the charging box for 5 seconds until the red and blue lights flash, and then release the button to reset the Bluetooth pairing information. Then follow the above Bluetooth pairing steps.

Lighting control

After wearing two earphones, double-click the left ear to switch between ten light colors while not answering any phone call.

Charging of earphones

Place the earphones into the charging case to recharge. At the beginning of charging, the headset light turns into blue and is permanently on.

Play/ Pause/Switch the music

When wearing both earphones, tap twice on the right earphone to pause/play the music; tap three times on the right ear one to play the next song. When wearing one earphone on any ear, tap twice on the earphone to pause/play music; tap three times to play the next song.

Charge the charging chamber

Charge the charging chamber with a charging cable. The prompt light of the charging chamber is in a blue flashing state when charging, and it will automatically turn off after fully charged. The input demand of the power supply of the charging chamber is USB 5v=1000mA. After the charging chamber is full, the headset can be fully charged for more than three times.

Voice assistant
While not answering any phone call, three clicks on the left headset will arouse the voice assistant (or Siri).
Scan the QR code or search “YOWU” in the APP store for further custom settings.

http://qr02.cn/Dot1f3

FCC STATEMENT

This equipment has been tested and found to comply with the I’m it’s for a Class 13 digital device autumn( to Reel 15 of the FCC Rites. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy. it nuts installed and used in accordance with the instructions. may cause harmful interference to radio communications, However. there is) a guarantee that interference MI does not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception tenth can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures
— Reorient or relocate the receiving antenna.
— ttCreLse the separation between the equipment and reereIVOG
— Connect the equipment into an outlet on a circuit different from that to which the receiver s connected.
— Consult the dealer or an experienced radioffV technician for help. Pis device complies with part 13 of the FCC Rides. Operation is subject to the folk/nine two conditions: (1) This donor: may not cause harmful intedemnne and (2) this dower: must accept any interference renewed, including inlarfeirmlon that Maly Clone iindosireal operation. Changes or modifications not expressly approved by the party responsible for compliance COUP void the user’s authority to operate the equipment.