Waykar PD160B 34 Pints Dehumidifier User Manual$
To prevent any internal damage, it is very important to keep the unit (like this one) upright throughout its journey.
Please leave it standing as the picture shown below and outside the box for 24 HOURS before plugging it in.
IMPORTANT NOTICE FOR FIRST USE
To prevent injury to the user or other people and property damage, the following instructions must be followed when using the Dehumidifier. Incorrect operation due to ignoring of instructions may cause harm or damage. This instructions are for household use only.
CAUTION
FRONT
REAR
This unit may have been tilted or placed upside down during shipping. To ensure this device works properly, please ensure this unit is upright for at least 24 hours before initial use.
This dehumidifier is designed to operate with a working environment between 41°F (5°C) and 95°F (35°C). When using dehumidifier, other objects surrounding the machine at least need to be kept a distance of 7.9 inches (20cm), as shown in the picture on the right:
Press to turn the dehumidifier on and off.
The humidity level can be set within a range of 30%RH to 80%R1-1 in 5% increments.
The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 1 hour to 24 hours. When the unit is running, selecting TIMER will turn the unit off in the set hours later (Delay Stop). When the unit is off, then the TIMER will turn the unit on in the hours you earlier selected (Delay Start).
TIMER setting: Press or hold the Timer Button to change the delay timer at 1 hour increment, up to 24 hours. After TIMER setting is finished, the control panel will display the remaining time (8, 7 or 6, etc.) until the unit starts or stops.
If then press TIMER button again, the control panel will display the room temperature and humidi-ty value as before. After that, adjust the TIMER setting to 00 will cancel the Auto Start/Stop function.
For the Delay Start, the fan speed and humidity maintained will be the same as previous setting.
NOTE
Control the fan speed. Press to select either High or Normal fan speed. A higher fan speed will result in quicker moisture removal.
Set the speed high for maximum removal first, when the humidity has been reduced and quiet operation is more preferred, you can return the speed back to Normal.
When the tank is full, the light will flash and the machine will automatically shut off. After the water in the tank is emptied, put the tank back in place, then the indicator will go out, and the machine will restart.
Power on:
Compressor starts after the fan work for a few seconds.
Power off:
Compressor shuts down at once, and the fan will stop after a few seconds. (When other malfunction occurs, or the humidity reaches desired level, the fan will stop after tens of seconds).
Tips:
The compressor features “3 minutes delay protection” function — While the dehumidifier is powered, the compressor can only start again three minutes after its last shutdown.
Fault Phenomenon | Analysis of Causes | Processing Method |
Humidity always shows “25% RH” — but there is a big difference from the actual humidity. | Humidity sensor failure? | Set the humidity to 30%RH,the dehumidifier can still continue to work, and can be used normally. |
Repair and replace the humidity sensor. | ||
Humidity always shows “99% RH” — but there is a big difference from the actual humidity. | Water on the surface of humidity sensor? | The dehumidifier is not affected and can continue to work, and can be used normally. |
Please let the dehumidifier keep working for a period of time, after the water on the surface of humidity sensor is removed, it will return to normal. | ||
Repair and replace the humidity sensor. |
There are two ways to remove the collected water:
When the water tank is full, remove the tank and empty it.
NOTE
Water can be automatically emptied into a floor drain by attaching a draining hose to the dehumidifier.(It may be helpful to remove the water tank first so you can see the connection better. )
Note: The inner diameter of draining outlet is 0.39 inches.
NOTE
WARNING:
Turn the dehumidifier off and remove the plug from the wall outlet before cleaning.
Wipe down the water tank every 2 weeks.
Pull up to remove the air filter . Clean the filter with water and cloth at least once every 30 days.
When not using the dehumidifier for a long time.
WARNING: Do not operate the dehumidifier without a filter. Because dirt and lint will clog it and reduce its performance.
Check the information below for troubleshooting steps, it will save you time to resolve issues that may happen with the unit.
The list includes most of the common cases, but not the results of defective unit, crafts or materials in the unit.
If all troubleshooting steps have been exhausted and the issue is still occurring, please feel free to reach out to Waykar Customer Service to get further assistance.
Problem | Reason | Method |
midifier does not work | The power cord is unplugged. | Make sure that the unit’s plug is inserted properly into the power outlet. |
Is the FULL TANK indicator blinking? (The tank is full or in a wrong position?) | Empty the water in the water tank and then reposition the tank. | |
Is the room temperature above 95°F (35°C)or below 41°F (5°C). | This product does not apply to over hot or cold environment. the machine; will automatically enter the protection Mode. It is a normal phenomenon. | |
Is the room temperature between 41°F (5°C) and 68°F (20°C) ? | When running under lower ambient temperature, the machine will auto-matically defrost, which is a normal phenomenon. It will restart dehumification again until the defrosting process finished. | |
The dehumidifier is in the defrosting process. | It is normal the compressor ceases while defrosting process. Wait until the process finished, it will restart dehumidification again. | |
Is the room humidity lower or reaching the preset humidity level? (When the room humidity has reached the preset level, the dehumidifier will enter Standby Mode and the indicator on LCD will flash. ) |
P please set the humidity decrease by 5% than the room humidity or set the humidity to 30%. |
|
This is to prevent the frequent start of the machine. Does the machine stop working just now? minutes. |
Please wait for more than 3 | |
Room humidity is low. | The dehumidifier is designed to work in the humidity range of 30%-80%. Above or below this range, it will not work. | |
Dehumidifier does not dry the air as it should | The air filter is dirty. | Clean the air filler. |
Is the air inlet or air outlet obstructed? | Remove the obstruction from the air inlet or outlet. | |
The dehumidifier size is too small for application. | Increase the quantity of dehumidifier. Or change to a higher capacity dehumidifier. | |
Poor air circulation. | Please leave about 7.9 inches (20cm)around the product. | |
Did not allow enough time to remove the moisture. | Allow enough time to remove the moisture. When first installed, allow at least 3-4 days to maintain the desired RH. |
|
The room has not been sealed properly. | Check that all doors, windows and other openings are securely closed. | |
Room temperature is too low, or below 41 7 (5C): The machine will not work or undergo poor dehumi- fying efficiency in low temperature. | Please wait until the temperature rises to above 5C or higher. | |
The dehumidifier makes loud noise when operating | The dehumidifier is not positioned levelly | Move the machine to a horizontal position. |
Is there blocking around the air inlet? The air filter is clogged. |
Clean up the dirt or lint on the air outlet and intake. | |
Is the filter installed correctly? | Please check whether the packing bag of the filter had been removed and the filter has been installed correctly. | |
Dehumidifier operates continuously | Check if the dehumidifier is in Continuous Mode | Do Not set the humidity too low. Typically. 40-50% are good for use. |
Room humidity is too high. | Change humidity settings. Or change to a higher capacity dehumidifier. | |
Doors and windows are open. | Ensure that all doors, windows and other openings are closed. |
Overflow of water on floor | Hose to connector or hose connection may be loose. | Connect the hose with the draining outlet tightly. |
The water tank has not been installed properly | Re-install the water tank properly. | |
The float of water tank has been stuck. | Move the float and let it swing freely. | |
The magnet on the float has come off. | Put the magnet in right position. |
Please contact Waykar Customer Service at [email protected] if the dehumidifier operates abnormally or does not operate, and the above solutions are not useful.
MODEL | PD160B |
POWER SOURCE | 120V — 60Hz |
RATED POWER (95°F, 90%RH) | 230W |
RATED CURRENT (95°F, 90%RH) | 2.0A |
MOISTURE REMOVAL (65°F, 60%RH) | 9.0 Pints/Day (4.25L/Day) |
MOISTURE REMOVAL (80 °F, 60%RH) | 14 Pints/Day (6.6L/Day) |
MOISTURE REMOVAL (86 °F, 80%RH) | 25 Pints/Day (12L/Day) |
MOISTURE REMOVAL (95 °F, 90%RH) | 34 Pints/Day (16L/Day) |
INPUT POWER (65°F, 60%RH) | 128W |
INPUT CURRENT (65°F, 60%RH) | L2A |
IEF ( 65°F, 60%RH) | 1.30 liters/kWh |
MOTOR FLA | 0.19A |
MOTOR COMPRESSOR | RLA: 2.5A LRA: 10.0A |
REFRIGERANT | R134a/5.11ozs (145g) |
MAXLMUM ALLOWABLE PRESSURE | 363PSIG (2.5MPa) |
HIGH PRESSURE | 232PSIG (16MPa) |
LOW PRESSURE | 90PSIG (0 62MPa) |
Warning:
This product can expose you to chemicals including Styrene and its compounds, which is known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information, please visit: www.P65Warning.ca.gov.
Waykar offers a 12-month warranty to all of our products together with the original proof of purchase when a defect occured, including those newly purchased and unused, from Waykar or through an authorized reseller, wholly or substantially, or as a result of faulty manufacturing parts, or workmanship during the Warranty Period. The warranty does not apply if damage is caused by other factors, including but without limitation of:
These are our general terms for the warranty service, but we always encourage our customers to reach out to us if any issues, regardless of warranty terms. If you are experiencing an issue with Waykar product, you can contact us at support@waykarcom we will dedicate our efforts to resolve it for you.
Register your product at www.waykar.com to extend your 1-year warranty by an additional year. Please fill out all required fields and inlcude your Order ID, Date of Purchased if applicable.
If you have any questions or concerns about your product, please feel free to contact our expert support team. Waykar customer service is here to help.
Waykar Office
13211, Spring Street Baldwin Park, CA, US
Email: support@waykarcom
Live Chat: www.waykar.com
Support Hours 24 Hours available *Please have your Order Number ready before contacting customer support.
For FAQs and more information please visit:
http://www.waykar.com/
(Scan the QR Code for Live Chat)
@Waykar
@Waykar
@Waykar
@Waykar
We are expecting to see our products fulfill your life and hear your voice.
Your satisfaction means a lot to us.
Please tag us if you share a snap on your social media.
http://www.waykar.com/