VIXEN HORNS – UseManuals https://usemanuals.com Owner's manuals for all sorts of products Fri, 31 Mar 2023 18:28:45 +0000 en-US hourly 1 https://wordpress.org/?v=6.7.2 https://usemanuals.com/wp-content/uploads/2025/02/favicon-32x32-2.png VIXEN HORNS – UseManuals https://usemanuals.com 32 32 VIXEN HORNS Sound Air Horn manual https://usemanuals.com/vixen-horns/sound-air-horn/ Fri, 31 Mar 2023 18:28:45 +0000 https://usemanuals.com/?p=44274 Read More...

]]>  

VIXEN HORNS Sound Air Horn Installation Guide

SAFETY INSTRUCTIONS

  • Make sure you never attempt to disassemble this horn kit’s electrical components.
  • Never use your bare hands to any part of the compressor immediately after or during use.
  • Avoid operating this product in an area with risk of falling or submergence into a liquid (water).
  • Do not reach out for or touch any component that has fallen or been submerged into water.
  • Make sure you set up in areas with good ventilation.
  • Never sound the air horn anywhere near your ear(s) or that of another person.
  • Make sure your battery ground is detached before getting your installation started.
    Employ equipment for eye protection during drilling operations.

MOUNTING

  • Identify a suitable area for mounting, preferably an unobstructed sheet-metal surface like the frame or body of the vehicle so as to provide a firm platform which will help protect the horn from damage due to excessive shaking. Do not attach the horn to any plastic or other flexible material.
  • Indicate the positions before drilling the hole of 1/4-inches in diameter. With the provided hardware for mounting, firmly tighten them to the vehicle.
  • Install the bolt’s head into the compressor housing’s slot. Tighten the compressor firmly to the vehicle with the provided mounting hardware.

IMPORTANT: Installation in a high location underneath the hood and the downward orientation of the trumpet will prevent the horn from collecting any water.

ELECTRICAL CONNECTIONS (FACTORY HORN SWITCH)

  • For vehicles with a two-terminal factory horn, transfer the wires to the compressor’s terminals. If the horn doesn’t sound even if the compressor motor turns on, simply reverse the wires.
  • For vehicles with one-terminal factory horns, make sure you transfer the wire to the compressor’s positive (+) terminal. The negative (-) terminal uses a 16-gauge wire or heavier to connect to ground.

ELECTRICAL CONNECTIONS (NEW HORN BUTTON)

  • Using a 15A fuse (not provided) for circuit protection, connect the positive terminal of the compressor to the power source.
  • The negative terminal of the compressor is attached to the horn button (not provided). The other horn button terminal is attached to any rust and paint free metal to ground.
  • IMPORTANT: Both connection must be done with 18-gauge wire or heavier.


]]>