CFP HUBBELL Lighting Instruction Manual

Instruction

NOTE:
Components shown in images are representative only and may vary based on the configuration ordered.

CAUTION:
Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation.

WARNING:
If any special control devices are used with this luminaire, follow the instructions carefully to assure full compliance with NEC requirements. If there are any questions, contact a qualified electrical contractor.

WARNING:
This product contains chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.

INSTALLATION METHOD

1: RECESSED MOUNTING

• STEP 1
  Raise unit into ceiling
  
• STEP 2
  Bend T-bar clips into position.
  

2: LUMINAIRE FITTING

• STEP 1
  Snap corner bracket to extruded rails, making sure that mounting flanges are on opposite sides.
  
• STEP 2
  Attach frame to ceiling structure.
  
• STEP 3
  Remove one non-mounting frame side and slide in flat-panel. Make all electrical connections using appropriate fittings.
  
• STEP 4
  Reinstall frame side to complete.
  

WIRING CONNECTION

*Wiring connection of both installation methods are the same

• STEP 1
  Open access plate. Use knockouts to connect power access using appropriately-sized electrical fittings.
  
• STEP 2
  Make wiring connections.
  

LUMEN SELECTABLE INSTRUCTIONS

Different lumen levels can be achieved by setting the switch on the driver cover to different positions

For 38W Product

2800/3300/4000 Lumens

For 52W Product

3400/4100/5500 Lumens

© 2020 Columbia Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice. 701 Millennium Blvd • Greenville, SC 29607 / Tel 864.678.1000 / Website www.columbialighting.com